pandaasebo.blogg.se - Fz 07 ecu flash

#Fz 07 ecu flash install#
#Fz 07 ecu flash full#
#Fz 07 ecu flash software#

Diagnostics: Read and Clear Fault Codes - (Requires Applicable V3 Interface).

Woolich Racing AutoTune - (Requires Applicable LogBox + Zeitronix Package).

#Fz 07 ecu flash software#

Purchase this item to gain access in the Woolich Racing Tuned software to the stock bin files for the 2021 Yamaha FZ-07 / MT-07.įeatures available for Yamaha FZ-07 / MT-07 2021 *** Pit Speed Limiter harness sold separatelyĢ014-2016 Yamaha FZ-07 / MT-07 Launch Control Keyīin File Definitions - for use in Woolich Racing Tuned softwareĢ021 Yamaha FZ-07 / MT-07 Stock Bin File Definitions

#Fz 07 ecu flash install#

If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply).Ģ017-2020 Yamaha MT-07 Race Tools Package You can purchase this as a package on the product page for your bike. You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. *** Pit Speed Limiter harness sold separately ** This harness uses the stock O2 plugs on the bike's harness, the stock O2 sensor should be removed from the bike and disabled in our software

* Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Pit Speed Limiter allows you to set the RPM to limit the speed while riding through the pits.*** Launch Control allows you to configure Delay, Launch RPM, Vehicle Release Speed The quickshifter kills both fuel and ignition.

#Fz 07 ecu flash full#

Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.

Race Tools Key to allow the use of the Race Tools on one ECU in the Woolich Racing Tuned software.

Yamaha Race Tools Harness Type 3 which allows the quickshifter to be plugged into the bikes wiring harness**.

Shift rod for standard shift configuration*.High quality strain gauge Quickshifter with digitally controlled pressure sensing that can be used in regular or race shift pattern.The Race Tools package allows you to enable Quickshifter, Launch Control and Pit Speed Limiter in the Stock ECU. Race Tools: Quickshifter, Launch Control, Pit Speed LimiterĢ014-2016 Yamaha MT-07 Race Tools Package